I recently purchased a new Insignia single tap kegerator. I hooked it up according to the manual, set the co2 to 12 psi, and turned the temp dial to 5 of 6., there is a 5' beer line. For days. I just bought a beverage air kegerator model bm23 off of craigslist. that right there is the problem. My Kegco XCK-1 kegerator has stopped cooling. I have done all the basics - checked the start capacitor, replaced the overload switch and relay, checked the controller and compressor windings. I am thinking that it has lost its refrigerant charge. It's R290. Has anyone had this issue or. I am using my chest freezer style kegerator as a fermentation chamber for my Hungarian Imperial Pilsner as it has very accurate temperature control. The problem is that I cannot tap a keg in the kegerator until the carboys are gone. My thought is that if I lager the Pilsner in kegs, I will. Kegco Kegerator a decent brand? Discussion in ' Home Bar ' started by rlm7189, Aug 23, 2019. Questions, tips, and general talk about bar setups at home. I recently bought an older beverage air kegerator from craig's list. I'm just starting to use it, have my beer in a corny key and it has been carbing up for almost a week now. I've noticed there is water building up on the bottom of the kegerator on the inside, and when i tried to find out. Can we use an indoor kegerator model outside? My summer climate is mostly mild with few days if any over 90. The kegerator would be on a raised concrete porch against the house, with full. The past weekend I heard random beeps in my beer room. Last night I traced it to the Kegco HBK163 kegerator. I unplugged it, waited a few minutes and then plugged it back in. This was when it started beeping continuously and flashing the E2 code. Was planning on calling their service department. Hello, My Danby kegerator keeps freezing and I can't adjust the temp without resetting. I've read through quite a few posts on here where people are discussing replacing the thermostat on their kegerators with either the STC-1000 or the ITC-1000 and I've settled on the ITC-1000 since it has both.